About this item:
Appilcation:
Sink Countertop,Shower Cubicle,Shower Door Bottom,Bathtub,Shower Floor
Installation method:
Measure:Measure the length and width of the countertop, In the corner, we recommend you cut it to 45 degree, and then connect two part to ensure its firmness.
Tear off the adhesive: in this process avoiding dust on the adhesive strip and affecting its adhesion.
Paste: apply the water dam seal gently and slowly, keeping it horizontal or vertical, pressing gently with your fingers.
Glue:The most important and necessary step is to fill the bottom edge of the water retention strip with caulk to ensure a long-lasting and strong adhesion.
Cautions: In order to achieve stable and lasting effect , please pay attention to the follow question
Purchase a size that is 5cm-10cm longer than the required length !
Clean the ground and dry it before installation!
This floor seal suit for kinds of Smooth flat floor, such as smooth marble floor, coating floor and other smooth surface. can not use for Severe sags and crests floor, big gap floor and Mosaic glass floor.
Not peeling all of sticker one-time: Mark the position and measure suitable length before peeling sticker, peeling sticker little by little one side and then press the peeled position to the surface as the same time, then peeling left little by little. Not peeling all of sticker for one-time and pull up the water retaining strip if found its not install well.
use with silicone sealant: Fill the gap between the walls with the two ends of the water barrier and all around of bottom by silicone sealant to achieve a completely hermetic effect, remove the excess glue to make the contact smooth.
After the installation is completed, it needs to be kept dry for 24 hours, and it needs to be postponed for 1-5 days in autumn and winter.
4.3 out of 5
86.15% of customers are satisfied
5.0 out of 5 stars Worked well
Used to seal the shower end of my bath where I have previously had trouble sealing and have used a chalk tape in the past. This stuck well, I also used silicon sealant behind it. Currently doing the job and looks clean and white still. Been on a few months now, hopefully will last over a year unlike the last tape I used.
4.0 out of 5 stars Ok jury's out.....for now
So what ta do, what ta do, what ta do!!!Easy to use, easy enough to be cut, bit of faff trying to get a clean cut(Note to self use longer sharp blade). But yeah make sure your blade isSamurai sharp! Better finish. Happyish with it TBH. But OCW (obsessive compulsive wife) will no doubt provide her wisdom on such affairs. 🤦🤷I used the tools pictured above to get the finish I was looking for.Although prior to sealing the edges that is. I will attempt to seal with myMake shift device and post on success or not🙄Four stars at the moment will update after next trial🫣.
5.0 out of 5 stars Bathroom
Yes great
3.0 out of 5 stars Use silicone to fix in place!
Looks decent enough but marked down as no way does that tape fix it well enough. Use silicone and it looks fine and stays put then
5.0 out of 5 stars Excellent shower strip for a water-tight seal.
I ordered this 4M/157inch Shower Strip to seal the gap between my bath and tiled wall. The old silicone sealant had become mouldy and was peeling away, causing leaks whenever the shower was in use. This shower strip has proven to be an excellent solution.Upon arrival, the strip was rolled up in a packet, which initially worried me as I expected a hard plastic material. However, it is a flexible silicone strip, making it highly adaptable and easy to work with. The quality is great and feels durable.Cutting the strip accurately was a bit tricky due to its flexibility. I did a few test cuts using a Stanley knife before making the final cut, and it worked out fine. The adhesive provided, however, is a waste of time in my opinion. It barely holds and is not suitable for creating a water-tight seal. If you’re only sticking the strip for aesthetics, it might work, but for preventing leaks, it’s ineffective.Instead, I stripped away the glue from the strip to make the surface flat and applied a generous amount of waterproof silicone sealant along the edges. Pressing the strip firmly against the bath and tiled wall allowed the sealant to squeeze out slightly, which I wiped away for a clean finish. Once dried, the seal was incredibly strong and completely water-tight. This method creates a much stronger bond compared to the adhesive it comes with.Overall, the quality of this product is excellent, and it provides a perfect solution for sealing gaps in the bathroom. The delivery was fast, and the service was great. Highly recommend this shower strip to anyone facing similar issues.
5.0 out of 5 stars Worked Fantastic
Had used other harder trims before but we're no good. This is plyable and easy to manipulate. I bought the one with stickers on the back just to position it but would recommend glueing and/or silicone to finish it
4.0 out of 5 stars Smartened bathroom up
Very good. Could have done with a wider area of adhesive as mould has managed to get under one edge
1.0 out of 5 stars Lost its stick almost straight away
Bought this along with 2 other different strips to seal the shower tray. This goes on easy, but lets water in behind and underneath it so it came unstuck. Totally not waterproof or useful in an area that gets wet. Ie: useless.
Cumple perfectamente
Queda perfecto y es fácil de instalar
Works great with some flaws
The seal works great in and off itself but there is a indented lip on the flat end where dirt and water can get trapped.I haven't had the seal for long and have had to hand wipe out suds and hair (we have some long and curly haired ladies in the family) that keeps getting stuck there almost on the daily.
ok
ok
Parfait
Pour l étanchéité d un évier cest top
Good purchase
We use it around our shower as we don’t have glass doors, it stops the water from going everywhere!
Visit the Zayejod Store
BHD17181
Quantity:
Order today to get by
Free delivery on orders over BHD 20
Product origin: United Kingdom
Or share with link
https://bolo.com/