About this item:
WIDE APPLICATION: Self-adhesive floor edge strip, threshold strip,transition strip,carpet edging strip,It is suitable for floor to carpet, floor to floor, laminate to carpet, threshold gradient transition of door edge, floor edging, carpet edging. MATERIAL: Environmentally friendly rubber PVC material, anti-aging, antibacterial, flame-retardant, dirt-resistant, non-toxic, safer than aluminum alloy threshold strips, does not damage the floor, and can be installed without drilling. SELF-ADHESIVE: Comes with adhesive tape, no need to drill holes during installation,it can be installed by tearing off the tape without damaging the floor.you can freely cut it according to your needs. safer than aluminum alloy material,and fit the ground better. SIZE: 3 meters in length, 30MM in width, 4MM in height, suitable for threshold transitions with a height less than 3MM. WARM TIPS: 1.Before installation, please clean the ground surface. If the surface is dusty, damp or greasy, its sticky might be affected. 2.When installing, first tear one end of the adhesive tape,sticking while tearing.DO NOT remove the whole tape at once.
3.6 out of 5
72.73% of customers are satisfied
5.0 out of 5 stars Did the job!
I needed something to cover the transition from laminate into a wet floor bathroom which was lower - this worked a treat. Very adhesive, easy to cut to size and after two previous failed attempts with other products mainly due to the height, this was third time lucky.My only gripe was the adhesive was only on one side(the lower side) however some glue sorted this. Very happy, especially for the price.
4.0 out of 5 stars Very useful if you have laminate to underfloor edge
It works, and provides a hard-wearing edge to laminate where it meets the subfloor or similar. Very easy to cut and fit.Only issues are its adhesive isn't very strong (easy to fix with additional glue or a small nail) and it looks a bit industrial
5.0 out of 5 stars Brilliant
Easy to cut, easy to fit. Perfect item to tidy up the small difference in levels between a tiled floor and a laminate one.
1.0 out of 5 stars Doesn’t stick
Wouldn’t stick so a complete waste of time and money
3.0 out of 5 stars Hardly sticks
Bought this product to bridge the gap between my laminated flooring and my lino in my bathroom and kitchen. First thing I noticed is the larger raised side is the one that’s got the sticky surface, which honestly doesnt make sense, you would expect the smaller flat side to stick to the higher part of your flooring and the raised side to simply sit on the lower part of the floor. Quality wise it looks pretty cheap and out of place when you place it down, but it was easy to cut and place, the black color seemed to trigger my robot vacuum to not attempt to cross the line and being that this was the whole reason I bought it so the robot could go over the gap easier without getting stuck especially when mopping, it basically was a massive let down. On top of that it just wouldn’t stay stuck down, the robot lifted it up multiple times and just standing near it made it pop up, so overall it didn’t fit down properly and was a waste of money as it didn’t work for me, but for other people who have a much smaller gap (My flooring was almost an inch taller than my lino) it may work, however I would recommend adding your own glue to make sure it remains stuck.
5.0 out of 5 stars Good product. Easy to use
Nice and easy to use. Good finish too.
5.0 out of 5 stars great product
done the job looks great
4.0 out of 5 stars Did the job.
Easy to use. Nice looking trim which has stayed in place so far.
Fixation et tenue non pratique
La barre de seuil n'est pas totalement droite car enroulée à la livraison. La colle ne fonctionnant pas bien le bout se relève et au bout d'un moment la barre se détache.
profilo
perfetto aderisce bene al marmo dopo previa pulizia con acetone
Bocciato
Preso per eliminare il dislivello (ovvero lo spessore di una mattonella) che c'era tra una stanza e un'altra, per facilitare le operazioni di pulizia di un robottino che sarebbe arrivato di lì a breve. L'adesivo non fissava abbastanza e la striscia era molto storta per via della forma arrotolata per la spedizione...Risultato: staccato tutto e buttato, il robottino supera tranquillamente il dislivello senza aiuti.
Visit the Zayejod Store
BHD10605
Quantity:
Order today to get by
Free delivery on orders over BHD 20
Product origin: United Kingdom
Or share with link
https://bolo.com/