Choose your country
Delivery choices and times vary depending on your location
Description:
About this item:
The low-profile 4-ft. long FMLWL LED Wraparound by Lithonia Lighting provides efficient and economical ambient lighting in surface-mount applications. It is ideal for many applications including corridors, kitchens, breakrooms, utility work areas and stairways.
Review:
4.6 out of 5
92.31% of customers are satisfied
5.0 out of 5 stars Great product
Very easy install, and emits a great amount of light with cost saving LED lighting rather than the more expensive to use florescent light fixture that it replaced. Also, it is much thinner and hence is less intrusive looking.
5.0 out of 5 stars No instructions
Hard to get end off if you do not know what you are doing.QR code no helpNice and bright.wiring outside unit, makes it easy to wire.
5.0 out of 5 stars Great light, easy to install
The lamp cones with all the needed installation hardware. It was a direct replacement that works great. An awesome lighting improvement for our garage. Great value for the money; should pay for itself with the electric savings.
4.0 out of 5 stars Good light, but industrial aesthetic, and only an average value (see details). Recommended
The issue that I was dealing with, was that the 4' fluorescent fixtures in my primary bedroom closets were having bulb and/or ballast issues. Why not replace the fixtures with something more efficient anyway? I was already familiar with Lithonia Lighting, as I've purchased some of their lighting products in the past, so it seemed like the Lithonia Lighting FMLWL 48 840 LED Flush Mount Wraparound Light (4-Foot, 4000k, Bright White) would be a decent choice.When I was taking down the old light fixtures, I noticed an issue... no J-boxes. Instead, Romex was poking through a hole in the sheetrock. Ugh. At least a ground wire was coming through, too, though it's a bad thing when that's the kind of thing that makes you happy. Did I mention that I was wall-mounting these? Because the Romex was coming through holes drilled in the framing over the closet door, there wasn't a quick or easy way to add a J-box in the same spot. I opted instead to go with a flush mount. There's a small, circular knock-out on the back of the light fixture, so I cut a grommet for that hole, pulled the white/black/green fixture wires back into the housing, and hooked everything up. It works, but there are issues. It appears that Lithonia Lighting just took an existing fluorescent housing, glued in a DC power adapter, and put in a 5050 light strip. Theoretically this makes this light easy to repair or modify, if that's your thing. Aside from the massive amount of wasted space, and shockingly high BOM cost vs. retail price markup, the location of the light strip makes it difficult to hide the wiring in a non-traditional installation like mine. Everything is downlight from the strip. Is that Lithonia Lighting's problem? Maybe not, but it's logical to assume that you might be able to use that massive housing for something.As far as the light goes, it's pretty good for the 8'x8' closets. Decent CRI, brightness, and diffusion (you don't see distinct hotspots where the surface-mount LEDs are). Aesthetically, you could best describe these as industrially functional. The housings look cheap, but the diffuser looks pretty good. I'm a little torn when it comes to the VALUE of these fixtures. On the one hand, ~$50 per fixture isn't bad... and I do expect them to last for several years. On the other hand, these seem pretty expensive for what you get. Recommended
5.0 out of 5 stars Easy to Install and Looks Great
I'm not a particularity handy person.I had the old florescent two tube light in the laundry room and it died a few weeks ago.I replaced the ballast unit and that didn't work.So, I replaced it with one of these units.This light looks much better and it was easy to install.Installation took me about 30 minutes including taking the old light down.I had a helping hand to hold the light in place while mounting to the ceiling.Very bright exactly like I wanted it to be.Very satisfied with this light.Seller and product highly recommended.
5.0 out of 5 stars Bright lights!
Nice LED lights for the garage! Easy installation, super lightweight and bright white light!
5.0 out of 5 stars Quality light.
Won’t be a direct replacement for a tube if your wires come in say on the end. I had to add a wire holder thingy. Used a spade bit. Then had to lengthen the wires. Nice and bright.
5.0 out of 5 stars Effective, no-frills lighting solution
Exactly what I wanted and expected. Went for the pure white light... Perfect for the garage. Replaced a dual-bulb fluorescent fixture. If you are running a three-way switch, plan on using your own wire nuts, as the ones that come with this package are not large enough to join three wires. IMPORTANT NOTE: This fixture attaches directly to the box, thus the alignment of the box will dictate the alignment of this fixture... You will have two choices, rotated 90 degrees from each other, because you will be using two of the four holes in the fixture to attach to the box. As always, your mileage may vary.
There is no bolbs reqvayerd
IT IS FANTASTISC
Best for garage
Had to replace old fashion fluorescent lights that were always burnt, flashing, etc and the changing of fluorescent tubes was a pain. Replaced all 4 with these , very easy install, very light and very good price compared to others at the nearest hardware store. No more tubes to changes and the garage has never been so bright
Faulty Light
The moment I turned on the power the driver for this light exploded internally. I hooked it up to 120v AC at 60Hz as it is intended to be.
Decent lights
Have had this lights for a while now. Easy to install and provides strong light for my garage! A little pricey for the quality of product but a decent value.
Five Stars
Great light....good price.
Visit the Lithonia Lighting Store
Lithonia Lighting FMLWL 48 840 Low-Profile LED Flush Mount Ceiling Light, Wraparound Lighting Fixture for Kitchen, Laundry Room, Garage, and More, 4-Foot, 4000K Cool White
BHD30467
Quantity:
|
Order today to get by
Free delivery on orders over BHD 20
Product origin: United States
Electrical items shipped from the US are by default considered to be 120v, unless stated otherwise in the product description. Contact Bolo support for voltage information of specific products. A step-up transformer is required to convert from 120v to 240v. All heating electrical items of 120v will be automatically cancelled.
All product information listed on the site are from 3rd party sources, including images and reviews. bolo.bh is not liable for any claims or promotions mentioned on the product description or images with textual content. For detailed product information, please contact the manufacturer or Bolo support by logging into your account. Unless stated otherwise during checkout, all import taxes and duty are included in the price mentioned on the product page. bolo.bh follows the rules and regulations of sale in Bahrain and will cancel items in an order that are illegal for sale in Bahrain. We take all the necessary steps to ensure only products for sale in Bahrain are displayed. Product stock and delivery estimate may change with the seller even after placing the order. All items are shipped by air and items marked “Dangerous Goods (DG)” by the IATA will be cancelled from orders. We strive to process your order as soon as it is finalized.
More from this brand
Similar items from “Close To Ceiling Lights”
Share with
X
Or share with link
https://bolo.com/