About this item:
BEHRINGER KM750 Professional 750-Watt Stereo Power Amplifier with ATR (Accelerated Transient Response).
4.8 out of 5
96.00% of customers are satisfied
5.0 out of 5 stars UPDATED 3-15-19!!! Original: Use in Bridge Mode for Home Theater subwoofer use
This amp ROCKS! No issues 5 months later. Highly recommended amp!Original: Bought this from the warehouse at an incredible savings. Using to power my DIY home theater subwoofer with a Dayton Rss315HO-12 4 ohm driver. When running in 'stereo' mode, the sub sounded anemic, no authority like it did with the 500 watt plate amp this KM750 replaced. I wasn't thrilled, but it wasn't so bad I would return it.Then, after having a few adult beverages one night, I made the executive decision to try bridging the amp and see what happens. Let me say, the sub came alive. I mean to the point of when it was 'stereo', and gain almost 100%, still sounded anemic. But with being in bridged mode, the gain is not even 1/2 way and the sub is ALIVE! [insert menacing laughter]. This is a GREAT amp for consumer use. Missing having a trigger control, which can be problematic, I got one of these that was recommended to me in a forum: https://smile.Bolo.com/gp/product/B00WV7GMA2/ref=oh_aui_detailpage_o04_s00?ie=UTF8&psc=1Now, the actual review since you now know how it is being used.The weight is good. The build/finish is 1st rate. No banana plugs can be used, but pins will work. I just used bare wire, 12 gauge. The power light is an extremely annoying and extremely bright white LED. A piece of electrical tape covering it cured that nuisance. The fan...what can I say. It isn't horrific sounding, but it IS annoying AF watching a movie and having it in the same room. Cool air is drawn in thru the top and warm air is exhausted out the left side. Used in a noisy commercial environment, the noise won't be noticed, but in your living room...What I did was to just plain disconnect the fan. I measured for several days the internal temperatures before, during, and after heavy home theater usage and have determined the very small gain in heat will be easily tolerated by the electronics for years to come,I recommend this amp. Dollar for dollar, pound for pound, watt for watt, you will find no better.
5.0 out of 5 stars Good Amp for dual In-Wall Subs/ Additional Power
I bought this amplifier to run two 10" in-wall subwoofers that I installed in my garage when I heated/ finished it. I knew that my stereo receiver wouldn't have the power to run 4 speakers and two subs, so I opted for this amp after a lot of reading and research. I have had the amp in play for the past 4 months and I am very pleased with its performance. I rarely run it at more than 1/4 volume and that gives more than enough punch in 2, 10", 8ohm subs (w/ boxes built into the wall). I will say, it is very fast, the bass is quick and not muddy at all.The only drawback of this amplifier in a practical sense for home theater, etc, is that you may need to pair it with an equalizer as the amp itself only has volume control. I did this in the garage instead of running another lowpass filter to my subs, but this was just because of my implementation more than anything.The fan can be a bit noisy but if you have it in a cabinet, or the music/ theater system at a typical volume for listening then I doubt you will hear it, I don't until I turn the music down.Overall, great performance for the price and it sounds great!
5.0 out of 5 stars Clean audio, and very attractive price!
Using this amplifier to drive two Peavey Impulse 6 speakers (one per channel), in a church so primarily vocals in this scenario. This amp provides extremely clean power to drive the speakers. The fan on the initial power-up was a bit noisy. After a few hours of burn-in the fan noise cleared up. I have not experienced any excessive heat from this amp and am comfortable with installing it in a wall-mounted rack enclosure. For the price I am very pleased, I have spent more on amplifiers and was pleasantly surprised with the sound quality even at the top end. If you have quality speakers with wattage and impedance requirements that pair with this amplifier you won't be disappointed.This is my first Behringer product and I am very impressed.
5.0 out of 5 stars Works Great
Works great. It had the right specs for the job we needed it to do and it's going great. we did need to get an adapter for the speakon jacks as we had 1/4-in and XLR setup. We have 1 channel for mains and 1 channel for monitors. This is a small open room setup (approx 3000 sq ft). Works great and would buy again.
4.0 out of 5 stars Terrific value and seems built like tank.
I purchased this to add the final two channels for 11.1 to my 9.1 Denon AVR-x4400h receiver. I wanted something with at least 120 watts per channel, but affordable. I’m not sold on the nuances of high end expensive amps. The KM750 is a bit industrial in it’s appearance and heft, probably a bit overkill for my setup. It is a beast.I’m driving a pair of Monoprice Amber 6.5” 3 way in-wall speakers on the front channels. After connecting it I got a pretty bad ground loop hum, so I had to lift the ground. Nice built in feature.So far I’m happy with the performance. Complaints? The built-in fan is noisy. Fortunately it gets drowned out once you start feeding audio. I wish it had a temp sensing speed control, but beggars can’t be choosy for the surprisingly low price. I also wish the power could be triggered by my receiver. I purchased an external triggered outlet strip. Finally the Power ON LED on the front is really bright and distracting while watching my TV in a darkened room. I put a small piece of blue masking tape over it. Light still manages to bleed through but is more bearable.
Awesome power. Great price point.
Been looking for a amp for my drum kit and this is the perfect solution. Best bang for your buck by far. Behringer does not disappoint.
Great amplifier!
Excellent value with outstanding audio quality.
clean and powerful
good clean powerful amp, only con i found is fans are really loud, might be a little overkill for a apartment or house
Four Stars
Good amp
good amp for the money
Installed this in to a retail location.. works as advertised. Came quickly
Visit the Behringer Store
BHD148801
Quantity:
Order today to get by
Free delivery on orders over BHD 20
Product origin: United States
Electrical items shipped from the US are by default considered to be 120v, unless stated otherwise in the product description. Contact Bolo support for voltage information of specific products. A step-up transformer is required to convert from 120v to 240v. All heating electrical items of 120v will be automatically cancelled.
Or share with link
https://bolo.com/