Rockville RPA14 10000W Peak / 3000W RMS 2-Channel Power Amplifier, Rack Mountable - Perfect for Live Sound, Pro Audio, DJs

Description:

About this item:

  • Features of RPA16: Rockville RPA16 10, 000 Watt Peak 2 Channel Professional/DJ Rack Mount Amplifier, LCD displays volume in dB per channel and operating temperature, 2U rack space, Built in limiter protects your speakers from distortion and clipping, Bridged mode allows you to combine both channels power into one channel for use with a subwoofer, Stereo mode is perfect for (2) speakers or (4) speakers in a left and right configuration.
  • Parallel mode gives you dual mono output signal which is perfect for monitor use when you want all sounds coming out of each speaker instead of a left/right configuration, Built in crossover switch (bypass, 80 Hz, 160 Hz) allows amp to be used with full range PA speakers, or Subwoofer(s), Channel A & B Clipping Led Indicators, Channel A & B Separate Level Controls, Power, signal, clipping, and protection LED indicators on front of amp, Heavy duty rack mount ears with handles.
  • Built-in variable high velocity quiet cooling fans, Maximum headroom for 4-ohm and 8-ohm Speakers, Level controls for precise setting and matching of sensitivity, Computer controlled IC protection circuitry against speaker short circuit, thermal over load, DC over load, User serviceable fuse (25A, 250V), Frequency Response (bandwidth @ 2Vrms out, @ -3. 0dB) 10 Hz – 30 Khz, THD + Noise @ 1Khz full power: <0. 04%, Input Impedance: 10K Ohm Balanced, Input signal voltage: 660mV – 1. 5V.
  • Input sensitivity: 0. 7v, Damping factor: ( 100Hz, 10w, 4 ohms): 36. 5, Damping factor: (1Khz @ 8 ohm): >400: 1, Effective damping factor (100Hz, 10w, 4 Ohms) 1. 08, Output impedance at speaker terminals: 0. 10975 Ohms, Frequency Response vs THD+N (worst case, across normal bandwidth 1W) 0. 6%, Signal to Noise Ratio: > 100dB, IMD 60Hz & 1kHz, 4: 1: <0. 04%, SLEW RATE (input filter limited) : 40v/uS, Power Requirements: 120V / 50-60Hz, Weight: 40. 8 lbs, Dimensions: 19. 09 x 16. 93 x 3. 35 inch.
  • Power Ratings of RPA16: RMS Power Output: Stereo 8 Ohm: 2 x 1000W, Stereo 4 Ohm: 2 x 1500W, Bridged 8 Ohm: 1 x 3000W. Peak Power Output: Stereo 4 Ohm: 2 x 5000W Max, Bridged 8 Ohm: 1 x 10000W Max.
  • Description of RPA16: Rockville RPA16 10, 000 Watt Peak 2 Channel Professional/DJ Rack Mount Amplifier, LCD displays volume in dB per channel and operating temperature, 2U rack space, Built in limiter protects your speakers from distortion and clipping, Bridged mode allows you to combine both channels power into one channel for use with a subwoofer, Stereo mode is perfect for (2) speakers or (4) speakers in a left and right configuration. Parallel mode gives you dual mono output signal which is perfect for monitor use when you want all sounds coming out of each speaker instead of a left/right configuration, Built in crossover switch (bypass, 80 Hz, 160 Hz) allows amp to be used with full range PA speakers, or Subwoofer(s), Channel A & B Clipping Led Indicators, Channel A & B Separate Level Controls, Power, signal, clipping, and protection LED indicators on front of amp, Heavy duty rack mount ears with handles. Built-in variable high velocity quiet cooling fans, Maximum headroom for 4-ohm and 8-ohm Speakers, Level controls for precise setting and matching of sensitivity, Computer controlled IC protection circuitry against speaker short circuit, thermal over load, DC over load, User serviceable fuse (25A, 250V), Frequency Response (bandwidth @ 2Vrms out, @ -3. 0dB) 10 Hz – 30 Khz, THD + Noise @ 1Khz full power: Input sensitivity: 0. 7v, Damping factor: ( 100Hz, 10w, 4 ohms): 36. 5, Damping factor: (1Khz @ 8 ohm): >400: 1, Effective damping factor (100Hz, 10w, 4 Ohms) 1. 08, Output impedance at speaker terminals: 0. 10975 Ohms, Frequency Response vs THD+N (worst case, across normal bandwidth 1W) 0. 6%, Signal to Noise Ratio: > 100dB, IMD 60Hz & 1kHz, 4: 1: ​​Terminals: Input Terminals: Combo jack (XLR and ¼”) A & B inputs. Output Terminals: Banana binding post speaker output, Speak on output, XLR output to connect another amplifier or powered sub.

    Review:

    4.5 out of 5

    89.23% of customers are satisfied

    5.0 out of 5 stars Good little amp

    D. · September 18, 2024

    Just like the other reviews, it does the job and so far so good...also it is like the bench test. It starts to get some distortion above 600 watts without clip light. It's very quiet for that much output. I have some DIY speakers with 2 12's Pro Audio woofers a DS 18 car midrange, polk and scanspeak tweeter, but I would not put that amp on my VMPS ribbon speakers. It didn't even care when I passive sub on it !

    5.0 out of 5 stars works great

    D. · August 12, 2024

    I've had a pair of jbl e90 floorstanding 3 way speakers for more than 20 years...never had them hooked up to anything other than a receiver with 100 watts per channel...what a shame...bought this RPA12 several months ago and hooked up my old jbl's ...unbelievable how great these speakers sound after all this time...all they needed was some real juice to make them sing...they're rated for 225 watts rms each so this amp has plenty of headroom...i can crank it really loud, and i mean screaming loud, and the volume is barely half way up while the sound is crystal clear...im 54 and don't give a shiat about my ears...they always ring and i don't want to hear what most people have to say anyway...i liked what this amp did so much that I've since aquired 2 RPA16's at 10,000 watts each and have built two boxes for 15 inch subs as well as two boxes for 8 inch subs...slapped a crossover and preamp unit on top of it all and just run all my music from my pc to the preamp through your standard 3.5mm pc audio jack...game changer set up from where i started with my first Rockville RPA12...I dont even use my sony stereo receiver anymore...no need to...got one build and one more amp to add....some devastating Orion HCCA midrange speakers married to one more RPA16 and then the neighbors will hate me more than ever...then my work is done....the RPA12 is more than enough wattage for most people and their setup....if you want to upgrade your setup and add some big subs or pro PA loludspeakers, just get the RPA16...the RPA12 is 5000 watts peak for $284...the RPA16 is 10000 watts peak for $100 more...thats 5000 more peak watts at your disposal for another $100...all of the amps I've bought have worked great and they are easy to use for anyone...no expert audio tech knowledge necessary...the user manual is like 7 pages and illustrates different setups and where you plug in the cables for said setups...idiot proof...get one...you'll be glad you did

    5.0 out of 5 stars Lightweight and POWERFUL...

    J. · June 10, 2024

    It should be noted that I ordered the D-14 which is LESS than 10 lbs and delivers a whopping 1400 watts (RMS) at 8ohms. (The non D rated amps are much heavier.) This all started when our small band began booking gigs OUTside where much more power is needed. We first purchased a pair of Rockville RSG 15" PA speakers (excellent also) and I didn't feel my Crown power amp was going to give us enough punch.Adding the D-14 with the RSG 15s has given us a very impressive sound system in a lightweight package. You cannot go wrong with this system and can be had at a much lower investment than a Crown, JBL, Yamaha, or QSC system. (One note though: In a studio application, you may find the cooling fan a bit loud for the environment. In a live venue, it's just fine.) HIGHLY RECOMMENDED!

    4.0 out of 5 stars Nice piece

    t. · September 30, 2023

    I purchased 2 12 inch Rockville 1128 subs and had em powered by a protect 2500 peak and it barely got em started. But this yeah it hits pretty good I must say and the link lets me drive my other 10 inch klipsh sub. The only thing I wish I had done was got the 4 ohm version of the subs. But 2 12’s @ 8 ohms and 2 sets of Rockville T150 towers it’s an awesome sound that you can actually feel all the way to the bone. Of course I don’t wanna leave out my 2-15 prorecks @ 2500 peak and a harbinger 4115 @ 2500 that’s a total of 12,000 peak with the new rpa12 @ 5000. I think I’ll purchase another one to drive my klipsh f 200 towers to complete the circle. Perfect for my home studio guitar playing . Wanna get rock ? They have a competitive product in quality for the price. Don’t be afraid to buy Rockville it’s good stuff.

    5.0 out of 5 stars Works good

    e. · September 27, 2024

    So far so good. I haven't used it for longer than 2 hours at a time yet but I am impressed. I have two 18 inch subwoofers I am powering with this and it had plenty of power. I had items vibrating off my shelves and walls in my house.

    5.0 out of 5 stars Been great

    a. · May 5, 2024

    This is pretty close to rated power i have had it a little over a year and still going strong pushin to polk s60 signatur elites rated at 350 rms each this amp is quite a bit more power than they will handle and i drive it hard every day no problems and they pound and it run fairly cool great for the price good and clean sound as well.

    1.0 out of 5 stars Do not buy this crap!!!

    A.M. · August 5, 2024

    Bought this Amplifier to power 2 18" Woofers rated 2000W each thinking well it's rated at 7000W so it should be more than enough only to have this thing crap out on the first gig i did using it, left me embarrassed as i had to complete the gig without any Bass as it didn't show any sign of power after only 2hrs of use......i which i could rate this as zero stars, worst piece of equipment i've purchased in a while, save your cash and buy a Crown,Qsc or Wasi Amplifier.

    5.0 out of 5 stars Sound is good, Build Quality Very Bad.

    M.P. · April 27, 2024

    It's got the power, clear and clean. However the build quality is just not there. First we had to modify the rack ears because they did not match the hole separation on the rack. It wasn't the rack because the good quality devices matched just fine.The one of the XLR input doesn't release the cable when the tab is pressed. Took allot of fiddling to get it out again. If I wasn't using it in a rack where I never need to unplug them I would have returned it.Now I am finding the option switches on the back for cross over and stereo/bridging will change position way too easy. Gonna have to tape them so they don't get knocked.Would recommend to spend $50 more and get something else. We will be replacing this as soon as we can, maybe keep it as an emergency backup.

    Great

    K.S. · July 1, 2024

    The amplifier is very good quality and the customer service is great.

    Excelente amplificador

    E. · April 21, 2023

    Es muy muy pesado, tiene un enorme transformador toroidal al interior, apenas pude levantar una tapa lateral y ver el interior, se aprecian algunos transistores de potencia, no he podido contar cuántos lleva, pero, ni he llegado a la mitad del volumen ya que entrega tanta potencia que las bocinas que tengo lo recienten, son las VP1520 de aprox 300W rms, y las mueve cómo si nada a 8 ohms. De verdad la mejor compra que puedes hacer.

    Se ve buen producto p

    R.M.G. · April 5, 2021

    En mi primer uso del amplificador. Muy bien muy buena potencia me ha sorprendido su potencia que da. Para 4 bocinas de 15 pulgadas. Así que hasta el momento bien.

    Excelente

    J.A.H.S. · July 25, 2023

    Buen aparato

    Exelente calidad de sonido

    I. · July 21, 2023

    Lo ocupo para mi grupo musical, conectando 2 grabes de 18 y suena muy bien para no castigarlo mucho. Lo recomiendo ampliamente.

    Rockville RPA14 10000W Peak / 3000W RMS 2-Channel Power Amplifier, Rack Mountable - Perfect for Live Sound, Pro Audio, DJs

    4.4

    BHD316544

    Quantity:

    |

    Order today to get by

    Free delivery on orders over BHD 20

    Return and refund policies

    Product origin: United States

    Electrical items shipped from the US are by default considered to be 120v, unless stated otherwise in the product description. Contact Bolo support for voltage information of specific products. A step-up transformer is required to convert from 120v to 240v. All heating electrical items of 120v will be automatically cancelled.

    All product information listed on the site are from 3rd party sources, including images and reviews. bolo.bh is not liable for any claims or promotions mentioned on the product description or images with textual content. For detailed product information, please contact the manufacturer or Bolo support by logging into your account. Unless stated otherwise during checkout, all import taxes and duty are included in the price mentioned on the product page. bolo.bh follows the rules and regulations of sale in Bahrain and will cancel items in an order that are illegal for sale in Bahrain. We take all the necessary steps to ensure only products for sale in Bahrain are displayed. Product stock and delivery estimate may change with the seller even after placing the order. All items are shipped by air and items marked “Dangerous Goods (DG)” by the IATA will be cancelled from orders. We strive to process your order as soon as it is finalized.

    More from this brand

    Similar items from “Power Amplifiers”