Amico 12 Pack 6 Inch 5CCT Ultra-Thin LED Recessed Ceiling Light with Junction Box, 1050LM Brightness, Dimmable Canless Wafer Downlight, 12W, ETL&FCC

Description:

About this item:

  • 5 CCT-in-1: 5 color temperature(2700K, 3000K, 3500K, 4000K, 5000K) is selectable to you, which successfully eliminates the hassle of returning or exchange products due to inappropriate color temperature. Just slide the switch on the side of the J-box and you will get the most-desired color that best fit in your room type.
  • IC Rated: Amico's canless LED recessed light is IC rated, which is permitted to be in contact with insulations in ceilings, meaning the junction box is thermally protected. It only requires as small as 2 inches ceiling space. It won't have a fire hazard when light was installed in various ceilings and overhead joists.
  • Easy Install: The low profile recessed lighting is suitable for retrofit and new decoration: Cut a hole in ceiling with 1:1 hole template; Connect the Jbox to the cable; Use spring clip to fix it on the ceiling. Hassle-free, the installation can be completed in minutes.
  • High Brightness: The 6 inch slim pot lights use the world's leading LED chips with higher lumens and lower power. 1050LM consumes 12 Watts, which equals to 110W halogen lamp, saving you up to 90% in energy costs a year.
  • Amico Benefits: Its long lifespan also reduces maintenance costs. All Amico's recessed lighting are certified by ETL of a high standard. Our customer support team will also address your concerns within 12 hours.
  • Review:

    4.8 out of 5

    96.00% of customers are satisfied

    5.0 out of 5 stars Well worth the money, bright and easy to install

    S.C. · August 18, 2024

    I can’t rave about these enough, they are well made, easy to install, sleek looking and make such a huge impression. I love the different temperatures available and that they’re dimmable. Because I have a flat roof with no attic access, I had to install them from under the ceiling, which was doable with a guiding coat hanger as a wire and minimal drilling through joists. The tools I needed: 14/2 electrical wire spool, electrical tape, 6” hole cutter saw drill bit and ABSOLUTELY BUY THE DUST BOWL ATTACHMENT, the job can get dirty quick, stud finder, voltage tester and that’s it. 75% of the job is just running the wire, a little time consuming, but once that’s all done you can finish the install in about 15 minutes just hooking it all up after daisy chaining. I will absolutely be changing my entire home to have this lighting, it’s incredible.

    5.0 out of 5 stars Excellent, design, quality, price

    J.S. · August 29, 2024

    I used 21 of these lights to retrofit several built in fluorescent fixtures from the 90's, in the kitchen & bathrooms. The 4" spot was a perfect fit for all of them. Wiring was simple with the control boxes. I needed to daisy chain the spots in gangs of 3 per panel which was easy to do. It saved me $$$$ over replacing the fixtures, which are an integral part of the cabinets. The only issue I had was the supplied connectors. I was using stranded 16awg wiring and these connectors only work well with either braided or solid wiring. it wasn't a problem since the control boxed easily accommodated using standard wire nuts, which I did. The selector Lumen switch was a big plus as I could dial in the brightness I needed in each room. The lights have been in use now for a month, with no problems.

    5.0 out of 5 stars VERY GOOD QUALITY

    D.T. · August 9, 2024

    These lights are very bright and adjustable for color temperature. The clean finish gives a sleek and prestigious look. The amount of brightness on the ceiling is also noticeable. The installation was easy for the electrician who enjoyed working with these lights or spotlights, especially considering the reasonable price.

    5.0 out of 5 stars Very nice light, easy to install, great design.

    B.S. · June 16, 2021

    I have installed a number of these lights and it is very easy to work with them. I would recommend cutting the off the quick connectors and just using standard wire twists for reliability and safety. Also don't forget to use metal box clamps when running wires into the boxes. The lights works exactly as described. They are the thickness of 1/2 drywall and can fit underneath floor joists and ceiling beams. That means you can pretty much install them anywhere you want without having to worry about the location of overhead timbers. The other really nice feature is the selector switch. Some of these lights are fixed and if you get one that is too bright you are stuck. These lights make it very easy to select different intensities which also affects the color tone of the light. The connector (junction + DC converter) boxes are metal and can be placed in insulation based on the instructions. The pigtail connectors are standard low voltage connectors and make it easy to connect or remove the LED light portion. The only compliant I have is the little metal box lid is not as sturdy as I would like to see. The hinge just snaps shut with no screw. I would like to see an optional screw to keep that lid shut as a preventive measure. Also you might have 1 out of a box of 12 that contains a defective pigtail adapter. But they are so low cost and work so well I am OK with a few defective lights.I highly recommend ordering a hole saw that is the exact size you need so they fit snug in the drywall. I ordered a really nice hole saw and a dust bowl also on Bolo. They both work really well to create the exact size holes I needed so the lights fit very snug and look good on the ceiling.I have not tested the lights with a dimmer yet but as with any LED light you have to get a compatible dimmer switch or you will see issues.

    4.0 out of 5 stars DIY friendly lights that look great

    A.G.H. · August 6, 2023

    My home was built without pre-installed, hard-wired lighting in most rooms. I upgraded the lighting in two rooms by installing these lights. They provide a nice clean look and great looking light.Room 1 is about 13' x 14' x 8', and has an open wall to a room with previously-installed recessed lighting. I installed 6 total lights set on 3000K. This setup provides fairly bright lighting, and a dimmer switch makes it easy to control. At full illumination, this room is observably brighter in broad daylight, with one wall consisting of a sliding glass door. At night, turning the lights down with a dimmer to about 50% provides plenty of light.Room 2 is about 10' x 10' x 8', and is an enclosed bedroom type space. I will soon install 4 lights in this room on the warm 2700K setting; I expect this to be sufficient.Installation Advice : I measured out my hole centers and then punctured the drywall with a thumbtack. Then, I used a 6" plastic lid from a half gallon yogurt tub with a thumb tack in the center as a stencil to mark my holes. After double checking that the holes are aligned, I used a hole saw to cut around the outer edge of the line describing the position of the yogurt lid. (That is, the hole radius was wider than the marked line by the width of the saw.) This approach yielded perfect holes with a durable stencil. For anyone that hasn't done this kind of work previously, it is dustier than I expected.Consideration 1 : 3000K on these lights is close, but not the same, as some retrofit recessed lights in an adjoined room that also list as 3000K. The 2700K on these lights much redder than the 3000K. These lights will work dangling from their connector so the light temperature switch can be checked before installing the light and hiding the jbox.Consideration 2 : My Leviton dimmer works with these lights, but the dimmer must rise above a certain threshold (about 60%) before the lights will come on from being off. This is mildly annoying.Consideration 3 : While it is possible to remove the light once it is in the ceiling, it is clear that these lights are not intended to be easily removed. I learned this while working out the proper hole size for the light.Consideration 4 : These do not come with bushings to protect wires from the metal edges of the jboxes. Order some to protect your wires! Bolo sells inexpensive plastic ones that are 1/2" in diameter.

    Amico 12 Pack 6 Inch 5CCT Ultra-Thin LED Recessed Ceiling Light with Junction Box, 1050LM Brightness, Dimmable Canless Wafer Downlight, 12W, ETL&FCC

    4.7

    BHD53111

    Quantity:

    |

    Order today to get by

    Free delivery on orders over BHD 20

    Return and refund policies

    Product origin: United States

    Electrical items shipped from the US are by default considered to be 120v, unless stated otherwise in the product description. Contact Bolo support for voltage information of specific products. A step-up transformer is required to convert from 120v to 240v. All heating electrical items of 120v will be automatically cancelled.

    All product information listed on the site are from 3rd party sources, including images and reviews. bolo.bh is not liable for any claims or promotions mentioned on the product description or images with textual content. For detailed product information, please contact the manufacturer or Bolo support by logging into your account. Unless stated otherwise during checkout, all import taxes and duty are included in the price mentioned on the product page. bolo.bh follows the rules and regulations of sale in Bahrain and will cancel items in an order that are illegal for sale in Bahrain. We take all the necessary steps to ensure only products for sale in Bahrain are displayed. Product stock and delivery estimate may change with the seller even after placing the order. All items are shipped by air and items marked “Dangerous Goods (DG)” by the IATA will be cancelled from orders. We strive to process your order as soon as it is finalized.

    More from this brand

    Similar items from “Housing & Trim Kits”